How many 400 × 600 mm pieces can you cut from a 2440 × 1220 mm sheet?
You can cut 12 pieces of 400 × 600 mm from one 2440 × 1220 mm sheet with a 3 mm saw kerf and rotation allowed — 97% of the sheet ends up in parts.
The layout is a straight grid, 2 across and 6 along the length, every part turned across the sheet. At 97% this is an efficient size for the sheet — under 4% goes to kerf and offcut.
Kerf and grain
The 3 mm kerf doesn't cost a part here: 12 fit with or without it.
Grain direction costs nothing here: with every part's 600 mm side running along the sheet's 2440 mm length you still get 12, so you can keep the grain consistent for free.
| Saw kerf | Rotation allowed | Grain-locked (no rotation) |
|---|---|---|
| 3 mm | 12 · 97% | 12 · 97% |
| None (theoretical) | 12 · 97% | 12 · 97% |
How many sheets for a batch?
| Pieces needed | 2440 × 1220 mm sheets | Last sheet |
|---|---|---|
| 10 | 1 | 10 of 12 — room for 2 more |
| 25 | 3 | 1 of 12 — room for 11 more |
| 50 | 5 | 2 of 12 — room for 10 more |
Same 3 mm kerf, rotation allowed. A part-filled last sheet is the place to nest drawer bottoms, shelves or anything else from the same material.
FAQ
How many 400x600 mm pieces can you cut from a 2440 × 1220 mm sheet?
You can cut 12 pieces of 400 × 600 mm from one 2440 × 1220 mm sheet with a 3 mm saw kerf and rotation allowed — 97% of the sheet ends up in parts. The layout is a straight grid, 2 across and 6 along the length, every part turned across the sheet.
How many 2440 × 1220 mm sheets do I need for 25 pieces at 400 × 600 mm?
3 sheets. At 12 per sheet, the last one carries 1 part, leaving room for 11 more.
How this was worked out
EZNESTING's nesting engine (the same one the optimizer runs, in its default least-waste guillotine mode) was given more 400 × 600 mm parts than could possibly fit on one 1220 × 2440 mm sheet, with a 3 mm kerf between parts and none at the factory edges. The parts it placed are the answer. That count is checked against simple grid layouts in both orientations (best of those: 12), so the page never shows less than a straight grid would give. No edge trim is assumed; if you skim 5 mm off a factory edge, re-run it in the optimizer with trim set.
Nearby sizes
- 420 × 560 mm from a 2440 × 1220 mm sheet — 10 per sheet
- 500 × 500 mm from a 2440 × 1220 mm sheet — 8 per sheet
- 410 × 650 mm from a 2440 × 1220 mm sheet — 8 per sheet
- 300 × 720 mm from a 2440 × 1220 mm sheet — 12 per sheet
Try any size in the sheet yield calculator, or lay out a full cut list with the plywood cut list optimizer, the 4×8 plywood cut calculator or the nesting optimizer.