How many 1000 × 1000 mm pieces can you cut from a 2440 × 1220 mm sheet?
You can cut 2 pieces of 1000 × 1000 mm from one 2440 × 1220 mm sheet with a 3 mm saw kerf and rotation allowed — 67% of the sheet ends up in parts.
The layout is a straight grid, 1 across and 2 along the length. 67% is middling — 33% of the sheet is left over, so it pays to nest these together with other parts.
Kerf and grain
The 3 mm kerf doesn't cost a part here: 2 fit with or without it. There's still 1220 × 434 mm left over after the last cut.
Squares don't care about rotation, so grain direction is free: lay every piece with the grain running the 2440 mm length and the count stays at 2.
| Saw kerf | Rotation allowed | Grain-locked (no rotation) |
|---|---|---|
| 3 mm | 2 · 67% | 2 · 67% |
| None (theoretical) | 2 · 67% | 2 · 67% |
How many sheets for a batch?
| Pieces needed | 2440 × 1220 mm sheets | Last sheet |
|---|---|---|
| 10 | 5 | full |
| 25 | 13 | 1 of 2 — room for 1 more |
| 50 | 25 | full |
Same 3 mm kerf, rotation allowed. A part-filled last sheet is the place to nest drawer bottoms, shelves or anything else from the same material.
FAQ
How many 1000x1000 mm pieces can you cut from a 2440 × 1220 mm sheet?
You can cut 2 pieces of 1000 × 1000 mm from one 2440 × 1220 mm sheet with a 3 mm saw kerf and rotation allowed — 67% of the sheet ends up in parts. The layout is a straight grid, 1 across and 2 along the length.
How many 2440 × 1220 mm sheets do I need for 25 pieces at 1000 × 1000 mm?
13 sheets. At 2 per sheet, the last one carries 1 part, leaving room for 1 more.
How this was worked out
EZNESTING's nesting engine (the same one the optimizer runs, in its default least-waste guillotine mode) was given more 1000 × 1000 mm parts than could possibly fit on one 1220 × 2440 mm sheet, with a 3 mm kerf between parts and none at the factory edges. The parts it placed are the answer. That count is checked against simple grid layouts in both orientations (best of those: 2), so the page never shows less than a straight grid would give. No edge trim is assumed; if you skim 5 mm off a factory edge, re-run it in the optimizer with trim set.
Nearby sizes
- 600 × 1200 mm from a 2440 × 1220 mm sheet — 4 per sheet
- 700 × 900 mm from a 2440 × 1220 mm sheet — 3 per sheet
- 500 × 1000 mm from a 2440 × 1220 mm sheet — 4 per sheet
- 600 × 720 mm from a 2440 × 1220 mm sheet — 6 per sheet
Try any size in the sheet yield calculator, or lay out a full cut list with the plywood cut list optimizer, the 4×8 plywood cut calculator or the nesting optimizer.